Fujitsu ST4000 Series manual Docking Your System, Undocking Your System

DOCKING YOUR SYSTEM

Microsoft® Windows® uses “plug- and-play” technology to automatically load the files necessary to operate your Tablet Dock and any attached devices.

Microsoft® Windows® uses “plug-and-play” technology to automatically load the files necessary to operate your Tablet Dock and any attached devices.

1.Plug the system’s AC adapter into a wall outlet, then into the Tablet Dock’s DC Input jack.

2.Set the ST4000 series system on the Tablet Dock, with the system oriented in the same direction as the dock. (See Figure 3 for location). The connector in the back of the system should be aligned with the interface connector on the Tablet Dock.

Tablet Dock User’s Guide

The front portion of the base should not be used as a handle.It is designed to support the system when it is installed in the Tablet Dock, but not as a handle.

UNDOCKING YOUR SYSTEM

Use these instructions when you want to remove your system from the Tablet Dock.

The system can be removed from the Tablet Dock whether the system is operating or not.

1.Press the lock release button on the top of the right slide (above the lock handle). While holding it down, pull the lock handle upwards to unlatch the back latches from the system.

2.Pull the system upwards, away from the platform. The system is now undocked.

Figure 3. Docking the system

3.Carefully push the system towards the docking port until you hear a click. The click indicates that the side latches are in place. Note that the system is not yet locked into place until the following step is performed.

4.Firmly pull the lock handle down as far as it will go. This engages the back latches and side latches, and locks the system in place.

5.Your Tablet Dock is now ready for use. You may now attach devices to it.

5