9
8Right-click on the FTvirtual Server icon
and select "Properties".
The [Component Properties] window ap pears.
9Select "FTvirtual Server" from the tree
on the left, check "enabled" in "Auto-
matic start" and click [Apply].
A red warning message will appear in the top of the
properties window but it just indicates a change in
properties and will have no effect on operations.
10
Click [OK] to close the [Component Prop-
erties] window and Endurance Manager
will end.
11
Set IP addresses for the following adapt-
ers.
Because DHCP is preset to automatically acq uire
IP addresses, if these IP add resses are acceptable
the following procedures are not requi red.
- CoServer1 "CoServer Management "
- CoServer2 "CoServer Managem ent"
- FTvirtual Server "Local Area Connection"
"Redirected0" in CoServer1 and CoServer 2 has
been reserved for use by FTvirtual Server. Do not
bind internet protocol (TCP/IP) to these adapters.
Set the FTvirtual Server LAN IP address and the
subnet mask on the FTvirtual Server.
12
If optional devices have been added
before running mini-setup of the OS,
refer to the following and perform op-
erations after expansion.
- When a 5-inch internal backup device is add-
ed
������������
"5.8.4 Procedure after Inst alling
the Internal Backup Dev ice"
2Click [OK].
After shutting down FTvirtu al Server, shutdown
CoServer1 and CoServer2 and the power supply
will be turned off automat ically.
When turning on the server again after turning it off,
wait for at least ten seconds and then press the power
switch.
If the server is turned on straight after being turned
off, an error will occur that may be cause damage.
8Turning the server off
Perform shutdown in the FTvirtual Server window using the following procedures.
1
Click [Start]
"
[All Programs]
"
[Mara-
thon Endurance]
"
[Management
Tasks]
"
[Endurance Conguration]
"
[Shutdown] in this order.
A dialogue box for conrming shutdow n will ap-
pear.