FUNAI BZV420MW8 owner manual Connection to AN External Tuner, Om the AC outlet

CONNECTION TO AN EXTERNAL TUNER

This section describes how to connect this unit to an external tuner such as cable/satellite box.										rear of your TV
	VHF / UHF
• When you change the connections, all devices should be turned off.
	antenna
• Refer to the manual accompanying external devices for				mo	re information.			2
1	Disconnect the power cords of the de							Disconnect		disconnect
			vice		s	fror	om the AC outlet.
							RF coaxial cable		ANT. IN
		Cable TV
	company

2Make the connection as illustrated below.

e.g.)

DVD/VCR

S-VIDEO IN ---AUDIO---OUT

L

AUDIO IN VIDEO IN

L R

RCA audio cable

rear of your TV

RF coaxial cable

ANT. IN

TV signal

RCA video cable

RF coaxial cable

		R		DVD			DVD/VCR
			DIGITAL	AUDIO S-VIDEO	COMPONENT	S-VIDEO	IN ---AUDIO---OUT
IN			AUDIO OUT	OUT	Y		L	L
					VIDEO OUT
	IN ---VIDEO---OUT				/CB	IN	R	R
					PB
							IN ---VIDEO---OUT
					PR
					/CR

rear of this unit

S-VIDEO	VIDEO	AUDIO OUT
OUT	OUT	L	R

OUT IN

or

S-video cable

RCA video cable external tuner

RCA audio cable

Supplied cables used in this connection are as follows:

•RCA audio cable (L/R) x 1

•RCA video cable x 1

Please purchase the rest of the necessary cables at your local store.

Note

•Required cables and connecting methods differ depending on the external tuner. For more information, please contact your external tuner provider.

With this setup:

•You can record any unscrambled channel by selecting the channel on the external tuner. Be sure that the external tuner is turned on.

•Signal from the external tuner can be output only on CVBS output even when the power of the unit is off.

•You cannot record one channel while watching another channel.

rear of your TV

3 Plug in the power cords of the devices to the AC outlet.

4After making the connection as described above, make sure to select the appropriate video input type by following the steps in “SETTINGS FOR THE VIDEO INPUT” on page 13.

connect

rear of this unit

Note to CATV system installer

•This reminder is provided to call the cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding - in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

12 EN