TO RECORD A SCRAMBLED/UNSCRAMBLED CHANNEL
1.Set the TV/VCR channel selector to the output channel of the Cable Converter Box or Satellite Box. (Ex. CH3)
2.Select the channel to record from your Cable Converter Box or Satellite Box.
EXTERNAL INPUT MODE
When using an external input signal (another VCR or video camera), connect the player’s audio/video out- put cables to the AUDIO IN/ VIDEO IN jacks of your TV/VCR. Then press the CHANNEL K or L button until “AUX” appears on the screen.
NOTE: “AUX” is found below the
lowest memorized channel.AUX (Example: CH2)
INSTALLING THE BATTERIES
1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.
2)Insert 2 “AA” penlight batteries into the battery
compartment in the direction indicated by the polarity
3)Replace the cover.
SET UP FOR USE
You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/VCR channel selector to the output channel of the cable box or satellite box (Ex CH3). Then select the channel to be viewed on the Cable Box or Satellite Box.
CHANNEL SET UP FOR THE
FIRST TIME
1Plug in the TV/VCR power cord
Plug the TV/VCR power cord into a standard AC outlet.
NOTE:
•If some digits appear in the corner of the screen, press the POWER button without unplugging the power cord.
2Turn on the TV/VCR
Press the POWER button to turn on the TV/VCR
3Select “ENGLISH” or “ESPAÑOL”
Select “ENGLISH” or | – SET UP – | |
“ESPAÑOL”=Spanish using the | B LANGUAGE | |
F.FWD/B or REW/s button. “[ ]” | [ENGLISH] ESPAÑOL | |
AUTO PRESET | ||
indicate the selected language. | ||
|
4Begin auto preset
– SET UP –
Press the PLAY/K or STOP/L but-
ton to point to “AUTO PRESET”. | LANGUAGE |
[ENGLISH] ESPAÑOL | |
Then press the F.FWD/B button. | B AUTO PRESET |
The tuner scans and memorizes all active channels in your area.
NOTES:
•The TV/VCR distinguishes between standard TV channels and cable channels.
•If you want to play or record a video tape BEFORE presetting the tuner, you must press the MENU button on the remote control. To preset the tuner again, see “CHANNEL SET UP AGAIN” on page 12.
•The TV/VCR may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto preset again in the fine receiving conditions.
5After scanning
The tuner stops on the lowest memorized channel. If you want to recall the selected channels, you can select the desired channel directly with the remote control number buttons or CHANNEL K or L.
- 10 - | EN |
9I03
