8
EN
INTRODUCTION

Attaching a Wall Mount Bracket (sold separately)

The following is a description of the method for attaching a wall mount to this unit.
When performing this operation, refer to the instruction manual included with the wall mount kit.

#

CAUTION
• Any damage caused by incorrectly attempting to mount this unit is not covered under the terms of the manufacturers warranty.
• This unit may be used only with CL-M manufactured by OMNIMOUNT SYSTEMS.
• Use with other wall mounts may result in instability causing possible injury.
You need the following wall mount kit for this unit.
Medium Cantilever Flat Panel Mount
Model number: CL-M
For more information, please visit OMNIMOUNT SYSTEMS website at www.omnimount.com/consumer/Default.aspx
5
1Spread a thick and soft cloth over a table. Place this
unit face down onto it. Make sure not to damage the
screen. At least two people are required at this step.
Note:
• Make sure to use a table which can support the weight of
this unit and is larger than this unit.
• Make sure the table is in a stable location.
2Unscrew the M4 screws indicated by 1 and remove the
stand. Please be careful with the unit after you remove
the stand.
Note:
• The M4 screws and stand you have removed are necessary
for reattachment at a later date. Make sure to keep them in
a safe place.
3Unscrew the M4 screws indicated by 2 an
d attach the
monitor plate to this unit using the M4×16mm screws.
You do not need to use the lock washers for mounting
this unit.
Note:
• Only use the screw holes indicated by 2 for mounting this
unit.
• For instructions on how to attach the monitor plate, refer
to the instruction manual included with the wall mount kit.
4Attach this unit to the wall. At least two people are
required at this step.
Note:
• Refer to the instruction manual included with the wall
mount kit when securing this unit to the wall.
* If you want to attach the stand of this unit again,
insert the stand slowly as illustrated below and drive
M4 screws in the 4 threaded holes (1).
2
rear of this unit
11
stand
* 1 and 2 indicate the
position of the screw holes
on this unit.
1
A71F6UH_FLX3220F_EN.indd 8A71F6UH_FLX3220F_EN.indd 8 2007/08/08 14:53:062007/08/08 14:53:06