- 15 - EN
CHANNEL SET UP
Make sure ...
•The unit must be turned on.

AUTO CHANNEL PROGRAMMING

As the initial setting, this unit has memorized all
channels, including the ones not available in your
area. This feature automatically puts only available
channels into the memory.
1Select “CHANNEL SET UP”
Press [SETUP].
Press
[
KK/LL
]
to point to
“CHANNELSET UP”, then press
[ENTER].
2Begin channel scanning
Press
[
KK/LL
]
to point to “AUTO CH
PROGRAMMING”, then press
[ENTER].
The tuner scans and memorizes all
the active channels in your area.
3After scanning
The tuner stops on the lowest memorized channel.
NOTES:
•When “AUTO CH PROGRAM-
MING” is activated where there
is no TVsignal input, “NO TV
SIGNALS” will appear on the
display after the completion of
channel scanning.
•The unit may recognize CATVchannels to be TV
channels if reception condition is poor. In this case,
check the antenna connection and try “AUTO CH
PROGRAMMING” again when reception condi-
tions are better.
•Channel memory programming is NOTneces-
sary when connected to a cable box or satellite
box. Just select the channel for cable box or
satellite input (ex. CH3) on the unit, then select
your desired channel on the cable box orsatel-
lite box.
TV
– CHANNEL SET UP –
ADD / DELETE CH (CATV)
BAUTO CH PROGRAMMING
- TV SETUP -
BCHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]

ADDING/DELETING CHANNELS

The channels you no longer receive or seldom watch
can be deleted from the memory. (Of course, you can
add the deleted channel into the memory again.)
1Select “CHANNEL SET UP”
Press [SETUP].
Press
[
KK/LL
]
to point to “CHAN-
NELSET UP”, then press
[ENTER].
2Select “ADD/DELETE CH”
Press
[
KK/LL
]
to point to
“ADD/DELETE CH”, then press
[ENTER].
3Enter the desired channel number
Press [CH. KK/LL]or the Number
buttons until your desired channel
number appears. (You can also
press [KK/LL]to enter it.)
•You must precede single-digit
channel numbers with a zero
(Example: 02 ... 09).
•When selecting cable channels which are higher
than 99, press [+100] first, then press the last two
digits. (Example: to select channel 125, first press
[+100] then press [2] and [5].)
4Delete (or add) it from (or into) memory
Press [ENTER]. The channel number changes to
light red. The channel is deleted from memory.
•To delete another channel, repeat steps 3to 4.
•If you press [ENTER] again, the channel is memo-
rized again.
5Exit the channel setup mode
Press [SETUP] to exit the menu.
NOTE:
•To confirm that channel(s) has been deleted or
added, press [CH. KK/LL].
– CHANNEL SET UP –
BADD / DELETE CH (CATV)
AUTO CH PROGRAMMING
08
ADD / DELETE
- TV SETUP -
BCHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
Added channel : Light blue
Deleted channel: Light red
(Example: CH8)
NOTV SIGNALS