Furman Sound HDS-16, HRM-16 manual Rear Panel, Ground lift switch has two positions

HDS-16/HRM-16 HEADPHONE DISTRIBUTION SYSTEM

Note: The remote and front panel switches are wired in parallel. Although either switch can activate the SOLO function, both must be in the off position to deactivate it.

is 200 ft. See Table 1 on page 8 for information about cable losses beyond 100 ft.

Push the AC-power switch up to the ON posi- tion to power the HDS-16.

REAR PANEL

The HDS-16 rear panel has six, 50-pin, Cen- tronics output connectors for the HRM-16s, AC-power, and ground switches (Figure 5). While male-to-male Centronics cables are available from computer retailers, Furman manufactures superior quality cables with twisted pair construction to optimize sound quality and reject cross-talk interference. We highly recommend using the 25 twisted pair, shielded, 25-ft cable supplied with each HRM-

16.Contact Furman for other cable lengths and linking adapters.

Note: The maximum recommended cable run

The GROUND lift switch has two positions:

LIFT: Signal ground is separate from chassis ground. Earth ground (AC line cord) is con- nected to the chassis only.

GROUNDED: Signal ground is connected to chassis ground; use this setting unless there is hum or noise present.

Note: Be sure all units are turned off before con- necting an HDS-16 to one or more HRM-16’s.

Figure 6: HRM-16 top panel

6