3.10 OTHER MENU Description
The table below summarizes the OTHER menu.
|
| Table |
|
|
|
| Item | Description |
|
|
|
1. | Panel Dimmer | Selects level of panel backlight. |
|
|
|
2. | Mark Brill | Selects brilliance of VRM, EBL, cursor, guard zone and WP marker. |
|
|
|
3. | HD Mark | Selects brilliance of heading marker. |
|
|
|
4. | Characters* | Selects brilliance of characters. |
|
|
|
5. | Trail Tone | Selects brilliance of echo trails. |
|
|
|
6. | Int Reject | Selects level of interference rejection. |
|
|
|
7. | Pulselength | Selects pulselength for 1.5 and 3 mile ranges. |
|
|
|
8. | Noise Reject | Selects “On” to reject noise. |
|
|
|
9. | Trail Time | Selects the echo trail time. |
|
|
|
10. | Tune | Selects automatic or manual tuning. |
|
| To tune manually; |
|
| 1. Select “Manu” by the omnipad. |
|
| 2. Press the [ENTER] key to enable manual tuning. |
|
| 3. While pressing and holding down the [GAIN] control, operate the |
|
| omnipad to obtain best tuning condition, observing the tuning indicator |
|
| bar (1.0~11.9V). |
|
| 4. Press the [ENTER] key. |
|
| “MANUAL” appears at the top |
|
| effect. |
|
|
|
11. | Disp Data | Select the down sourse to display. |
|
| Selects data to display; Nav, ARP, or All (both Nav and ARP). |
|
|
|
12. | WPT Mark | Selects “On” to display the waypoint marker. |
|
|
|
13. | EBL Ref | Selects EBL reference for relative or true. |
|
|
|
14. | VRM Unit | Selects distance unit of VRM and cursor for nm, km or sm. |
|
|
|
15. | Watchman | Turns watchman on (set rest period) or off. |
|
|
|
16. | STBY Disp | Select the display to use at |
|
| go into the economy mode. |
|
|
|
17. | Guard Mode | Select condition which triggers guard alarm; targets entering guard zone |
|
| (In), target exiting guard zone (out). |
|
|
|
18. | Own Position | Select position display format; L/L on Loarn TD. |
|
|
|
19. | Cursor Posi | Display the cursor data in range/bearing or lat/long. |
|
|
|
20. | Alm Sense LV | Select minimam echo strength which triggers guard alarm. |
|
|
|
21. | Dead Sector | Select “On” to display the dead sector. |
|
|
|
22. | Range | Select ranges to use. |
|
|
|
23. | Self Test | Test keys, ROM and RAM; checks antenna rotation speed, and displays |
|
| program no. |
|
|
|
24. | Installation Setup | Displays to the installation setup menu. |
|
|
|
*Note: Level 1 and 2 are same brilliance while the menu is displayed.The brilliance changes after the menu is erased.