Furuno FELCOM 250, FELCOM 500

3. SETTING AFTER INSTALLATION

These handsets can be used for communication. However, the following screen does not update

automatically. Press the Reload button of the browser to refresh the screen.

Contents

Main Installation Manual INMARSAT FLEETBROADBAND FELCOM 250/FELCOM 500 Page i SAFETY INSTRUCTIONS WARNING CAUTION Indicates a condition that can cause death or serious injury if not avoided. SYSTEM CONFIGURATION Antenna unit FB-1500 (FELCOM 500) FB-1250 (FELCOM 250) Communication unit FB-2000 iii EQUIPMENT LISTS Optional Supply Standard Supply *: See lists at the back of this manual. iv 1. HOW TO INSTALL THE UNIT 1.1 Antenna Unit General Secure unobstructed path in all directions Select a location low in vibration WARNING Minimum distance from other antennas Compass safe distance Other mounting guidelines Guardrail, platform Mast strength Antenna mast and mounting base FELCOM 500 FELCOM 250 FELCOM 500: How to install the antenna unit Procedure Page 9. Restore the lifting lugs to their original positions. FELCOM 250: How to install the antenna unit Procedure Page How to mount the FELCOM 250 antenna unit with optional pole mount kit 1.2 Communication Unit How to install the CU 1.3 IP Handset 1.4 Incoming Indicator (option) How to install on the bulkhead or bridge panel How to install by the flush mount Page 1.5 Facsimile FAX-2820 (Option) How to change modem settings 1.6 Telephone FC755D1 (Option) General Mounting location How to mount Label (16-007-6927-0) Page 2. CONNECTIONS 2.1 Standard Connection FR-FTPC-CY, 10/20/30/50/100 m 8D-FB-CV, 30/40/50 m Run and connect cables, refering to the figure below and the interconnection diagram (page S-1). 2.2 Antenna Cable How to attach the antenna cable connector N-P-8DFB-CF How to attach the antenna cable connector N-SP-12DSFA-CF 2.3 Communication Unit Telephone FC755D1 and Facsimile FAX-2820 TTYCS-1 Cable fabrication NMEA signal, External alarm Cable fixture 2.4 Notice for network connection Never connect as follows: 2.5 Desktop Installation of Communication Unit to- comply with IPX2 (dripping) standard How to inset the grommet How to install the connector cover Page 2.6 LAN Cable Fabrication Armor 150 Inner vinyl sheath Outer vinyl sheath Wrap vinyl tape 25mm approx. 9mm approx. 9mm approx. 11mm Drain wire 3. SETTING AFTER INSTALLATION 3.1 Preparation for Setting Page Page 3.2 GPS Setting 3.3 Analog Port Setting 3.4 Incoming Indicator Setting 3.5 Serial Port Setting 3.6 Satellite Setting 3.7 OTA Setting 3.8 Handset Setting Web software setting Setting in the IP handset Page Page AP-1 APPENDIX 1 JIS CABLE GUIDE D T M TT MPYC - 5 PY CYS -S A-2 -1 %2 #3: -4 A-3 %2 #3: ($ A-5 ($# A-6 12 -10 -9 Modular jack box Page Page Page Page Page Page Page Page Page Page S-1 66#-#*#5*+ ($#$ 2% 14 4176'4 0'6914- '37+2/'06