Specifications
| AE115 Unit | AE125 Unit |
Voltage supply | 2 x 240V AC (Canada 240VAC) | 3 x 240V AC (Canada 240VAC) |
Amperage | 2 x 40 A (Canada 80 A) | 3 x 40 A (Canada 120 A) |
Maximum output | 17.25 kW | 26.85kW |
Temperature control range | 95°F to 131°F | 95°F to 131°F |
Pressure range | 15 psi to 150 psi | 15 psi to 150 psi |
Minimum flow rate | 0.6 US gal / min | 0.8 US gal / min |
Maximum flow rate | See Graph 1, Page 8 | See Graph 1, Page 8 |
Dimensions (excl. water couplers) | 15½” H x 151/4” W x 4½” D | 15½” H x 151/4” W x 4½” D |
Weight (without water) | 20 lbs | 22 lbs |
Note: The unit will work at lower supply voltages but the following changes will apply: | ||
Maximum output | 15kW at 220V | 22.5kW at 220V |
| 13kW at 208V | 20kW at 208V |
Temperature control range | 87°F to 116°F at 220V | 87°F to 116°F at 220V |
| 82°F to 108°F at 208V | 82°F to 108°F at 208V |
Maximum flow rate | 84% of maximum at 220V | 84% of maximum at 220V |
(refer to Graph 1, Page 8) | 75% of maximum at 208V | 75% of maximum at 208V |
Installing the PowerStar
WARNING:
If water supply has a high mineral content, a water softening system is strongly recommended. Damage to the water heater resulting from scale or hard minerals will not be covered under warranty.
DISCLAIMER:
In the Commonwealth of Massachusetts a licensed plumber or electrician must perform the installation. (Approval number:
Locating the Powerstar
WARNING:
Do not install the water heater in an area where there is a chance of freezing. Damage to the water heater as a result of freezing will not be covered under warranty.
∙If being used in a public place, locate the heater out of easy reach to discourage vandalism.
∙Mount the unit onto a flat section of wall, well away from any potential splashes of water or spray and away from areas where direct moist or wet contact could occur.
Should it be necessary to service the Powerstar, observe the following clearances. These are not required clearances, but would facilitate any service work.
Recommended minimum clearances for servicing
Top | 12” | Bottom | 6” |
Sides | 0” | Front | 12” |
3
