Furuno FR-2155 manual Cable fed from outside display unit, Cables fed from bottom of display unit

Cable fed from outside display unit

Shielding foam (D) Rear clamp plate

(C) Signal clamp

(Aluminum)

(A) Rear clamp base

M5x10 (2 pcs)

(B) Power clamp

(Aluminum)

Bottom clamp front plate (Installation materials)

(Installation materials)

Rear cable entrance

(Display unit, right-hand side view)

Figure 2-10 Clamp position outside display unit

•Place shielding foam between cables inside of display unit, and then attach foam to chassis.

•Fill unused clamp holes with shielding foam.

Cables fed from bottom of display unit

Lead in cables through the cable clamp at the rear of the console and ground their shields in the cable clamp. For signal cable, remove vinyl sheath where cable lies in cable clamp. Fasten cables with cable ties.

CloseCloseshuttershutterdoorandcover it withwithaluminumtapetapeto tokeep foreignkeepobjectsforeignoutobjectsof the out

displayof theunitdisplay. unit.

Seventh hole from the top

	Power Cable
	(For display unit)
Gyrocompass Log		Signal Cable
Performance	NAV	ARPA
Monitor		Slave Display
Power Cable

(For PM)

Cable Arrangement in the Console (Top view)

SIGNAL CABLE:

Remove the vinyl sheath here. (1300 mm from display unit end

of cable remove sheath by 70 mm.)

Figure 2-11 Clamp position at bottom of display unit

2-7