2. WIRING
2.2.4Connection of Terflex ® linear sensor
When connecting the Teleflex ® linear sensor AR4102/AR4302 instead of the
1.Cut the black jumper at the back of the AR4102/4302. DO NOT cut the red jumper.
2.Make the cable connection as shown below.
3.Change the position of jumper switch
4.Set SELECT RRU to “LINEAR SENSOR” on the DOCKSIDE SETUP menu. For further details, see chapter 3.
Processor unit | TB13 | |
| ||
|
| |
|
| 1 |
|
| 2 |
SPU Board |
| 3 |
(64P1140) |
|
|
| 4 | |
|
| 5 |
|
|
|
RED
WHT
BLK
Linear sensor
AR4102
or
AR4302
For BARE line, wind tape around where shield was removed.
Connection of linear sensor AR4102/AR4302