3. STEERING MODES
3.3NAV Mode
3.3.1Starting the NAV mode
If a destination waypoint is set on a GPS / Plotter, the
Note: It takes 5 seconds to activate the NAV mode after the
1.Set the destination waypoint (or route) on the plotter.
2.Manually steer the boat towards the waypoint.
3.Press and hold the [NAV] key down until the following message appears.
NAV TO _ _ _ _ _ _ _
FROM PORT 1?
ARE YOU SURE?
YES...PUSH ENTER KNOB.
NO.....PUSH ANOTHER KEY.
4. Press the course control knob to go to the NAV mode.
Course to the destination waypoint
Track control mode (NAV)
Selected | NAV | 359 |
|
| |||||
SRC: PORT 1 |
|
| |||||||
Navigator |
|
|
|
| |||||
|
|
|
|
| HDG | 359.9 |
| Heading from | |
Heading mode |
|
|
|
| M |
| |||
|
|
|
|
| |||||
|
|
|
|
| heading sensor | ||||
M: Magnetic |
|
| |||||||
RUDDER | 0 | ||||||||
T: True |
|
| |||||||
|
|
|
| ||||||
|
|
|
|
|
|
|
|
40 20 10
10 20 40
Rudder angle (or XTE)
NAV mode display (Normal display 1)
Note that while in the NAV mode, the course reading on the
When you want to navigate a route, make sure that your plotter is navigating towards the nearest or desired waypoint before putting the
5. Press the [STBY] key to terminate the NAV mode.
Note: You can change the port to use by pressing the course control knob over three seconds.