003 INSTALLATION
INSTALLATION
IF ANY MODIFICATION TO THE VESSEL IS REQUIRED, SUCH AS DRILLING HOLES ETC FUSION RECOMMENDS CONSULTATION WITH YOUR BOAT DEALER OR MANUFACTURER BEFOREHAND.
»» Create mounting hole for product and drill Screw | Note: Appropriate mounting is very important to |
Pilot Holes. | ensure correct operation. Select a location that allows |
Refer to mounting template included with product | both free/open airflow around rear of chassis, whilst |
or download from www.fusionelectronics.com | minimizing exposure to moisture. Allow adequate |
»» Fit mounting gasket | room at the rear of the unit for the cable looms |
»» Insert the unit into the mounting hole | (approx 2”). |
| |
»» Use the supplied 4 x self tapping screws, to affix |
|
the unit into position. |
|
»» Attach screw covers |
|
| Mounting Hole |
Screw Pilot Hole |
|
Mounting Gasket |
|
004 INSTALLATION
Rear support holes
In some cases a rear support strap (not supplied) may be required. Please use the two holes indicated above, to attach the strap using two 8 gauge x 8mm
Screw Covers
ELECTRICAL WIRING
INSTALLATION WARNING
»» Ensure the marine vessels +12V lead is removed from the battery before any equipment is connected
»» Investigate the marine vessels fuel tanks and
electrical wiring locations before you begin installation
»» Ensure all wiring is protected to avoid damage
When wiring the
Note: Ensure the Aerial cable is routed away from any power cables, and is the minimal length, as long cable runs will affect AM reception performance.
For optimum radio reception please ensure you use an independent am/fm marine antenna (ground independent).
Please refer to the following site for further info: www.pacificaerials.co.nz
Caution: The