Gaggenau VK230610 manual Installation

7.3 Installation

8,5 288

510

190 280

1,7 m

		5
	min	. 3
min	. 50	490

268
3	65	94	3
651	13	25

Fig. 16

Fig. 17

Fig. 18

–Produce the recess for one or several Vario appliances in the worktop. Proceed as shown in the installation sketch and the dimension table. The dimension table contains the space requirement for the connecting strip between the appliances.

Important: the angle between the cut surface and the worktop must amount to 90°. (Fig. 16)

–Mark the centre of the recess exactly. Secure the securing rails on both sides in the recess. Make sure that the lugs of the securing rails lie on the worktop and that the centre marking on the securing rails is precisely flush with the centre marking on the worktop (Fig. 17).

Secure the cover on the appliance before assembly. See assembly instructions VD 201-010.

–Lower the appliance into the worktop. Make sure that the engaging lugs on the appliance lie exactly on the clamping springs. Press the appliance firmly into the worktop. The engaging lugs on the appliance “snap" into the clamping springs (Fig. 18).

Note: When installing the appliance in granite or marble worktops, have the holes produced by a specialist or stick on the securing rails with a temperature-resistant 2-component adhesive (metal on stone).

Note:

Several appliances can also be installed in individual recesses, as long as a minimum clearance of 40 mm is kept to between the appliances.

19