Gaggia 037RG manual Adjusting the Coffee Length, Standby, Dispensing Spout Adjustment, Been brewed

Blinking

The machine allows slight adjustments to the coff ee grinder to adapt it to the kind of coffee used.

To make any adjustment, press and turn the knob inside the coffee bean hopper.

Press and turn the knob by one notch at

atime and brew 2-3 cups of coffee; this is the only way to notice differences in grind.

The reference marks inside the coffee bean hopper indicate the grind setting. There are 5 different grind settings to cho- ose from with the following references:

Large Mark - Coarse Grind

Small Mark - Fine Grind.

Adjusting the Coffee Length

The machine allows you to adjust the amount of brewed coffee according to your taste and/or the size of your cups.

Each time the “ “ or ““ buttons are pressed and released, the machine brews

apre-set amount of coffee, as per factory settings. This amount may be reprogram- med to your taste. Each button may be individually programmed for a specific brew setting.

As an example, the following procedure describes the programming of the button

““, which is normally associated with espresso coffee.

•Place a cup under the dispensing spout.

•Hold the “ “ button pressed for 5 seconds to enter the programming mode; the “ “ icon will blink quickly and the coffee will start to be brewed; the icon will flash during the whole coffee brewing cycle.

•Press the“ “ button again when the amount of coffee in the cup reaches the desired level.

At this point the button“ “ is program- med; each time it is pressed and released, the machine will brew the same amount of coffee that was just programmed.

The same operation can be repeated for
the “	“ button. If the “	“ or “	“	English
button is pressed twice to brew coffee,

the machine will brew double the stored quantity.

Standby

The machine is designed for energy sa- ving. The machine automatically turns off after 60 minutes of inactivity.

The““ button blinks when the machine is in stand-by mode.

Note: During the turning off phase, the machine performs a rinse cycle, if a coffee product has

been brewed.

Warning: When turning the machine on after it has been turned com- pletely off, the machine will be in stand-by mode

To turn the machine on again simply press the STAND-BY button (if the power but- ton is set to “I”). In this case the machine will go through the rinse cycle only if the boiler is cold.

Dispensing Spout

Adjustment

Most cups on the market can be used with this coffee machine.

The height of the dispensing spout may be adjusted to better fi t the dimensions of the cups that you wish to use.

Manually move the dispensing spout up or down to adjust its height by placing your fi ngers as shown in the fi gure.

The recommended positions are: For use with small cups;

• 31 •