Gaggia 12300 manual Keeping it clean, Descaling, English

Models: 12300

1 11
Download 11 pages 29.95 Kb
Page 9
Image 9
Keeping it clean:

Keeping it clean:

1IMPORTANT: the steam nozzle should be cleaned after each use in order to avoid build up of milk deposits that are very difficult to clean. Cleaning is made easy as can be seen in the DESCRIPTION OF PARTS. The outer part of nozzle can be removed by pulling downward.

The outside of the steam pipe can be cleaned with a damp cloth.

The steam jet is cleaned by running a shot of steam through it.

The hole in the steam nozzle must be kept open. A needle may be used.

2Clean filter holder and filter in warm water after use.

ENGLISH

7If the machine is not used for a long period of time, discharge the water from the boiler by turning the steam knob clockwise (25), and put the hot water/coffee switch on “On”. Let a quantity of water equal to two cappuccino cups come out of the frother. Close the steam knob (25) and put the hot water/coffee and the steam switch on “Off”. Turn off the machine.

Never operate pump unless there is water in tank.

8NOTE: It is very normal for an espresso machine to emit steam and drip occasionally as the water pressure changes during use.

Be certain to empty drip tray (12) as requi- red.

Pay attention as the

Descaling: Turbo-Frother steam Manual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual backgroundManual background nozzle could be hot!

Air intake to be kept clean

and free from residues.

3Wipe body of machine with a damp cloth as required.

4Remove basin and grid (12, 23) and rinse with water. Do not use abrasive substan- ces.

5Clean the seal (15) inside of the brewing head (14) and keep it clean.

6The shower disc (17) should be unscrewed and cleaned periodically depending on frequency of use.

Descaling:

In hard water areas, minerals found in the water will accumulate and affect operation of the unit.

Approximately every two months (this can vary depending on use and water condition), clean the machine with Gaggia descaler (in which case follow the instructions on the packet).

Remove shower disc (17) and clean.

Pour solution into tank and turn on pump for 15 seconds. Allow solution to flow through brewing head and steam nozzle for several seconds. Wait 20 minutes, then repeat. process until solution has been run through.

Rinse machine thoroughly by running plain cold water through machine. Replace shower disc (17).

NOTE: Product failure due to scale accumu- lation is not covered by warranty. No other servicing should be attempted by the user. Use “Gaggia cleaner” for best results.

• 13 •

Page 9
Image 9
Gaggia 12300 manual Keeping it clean, Descaling, English