Garland G280-2 operation manual Specifications, Installation

SPECIFICATIONS

Model G280-2

Oven interior dimensions are 26¼” wide (667mm) x 22” deep x 13½” high (343mm), designed with embossed side liners to achieve the maximum in thermal convection action for uniform heat distribution and control. Oven sides, back, deck and door linings coated in porcelain enamel make clean-up easier and ensure long life. Burner compartment is lined with corrosion resistant steel. Heavy oven rack provided (one rack per oven standard), with adjustable in two positions. Oven input is 35,000 BTU’s (10.25kW) per cavity. Individual on-off valve and 100% safety pilot system provided as standard equipment. Door springs and 100% safety pilot system are located out of heat zone and easily accessible for maintenance.

Models M1R and M2R

High capacity oven is 13½” high (343mm) x 26 ¼’ wide (667mm) x 29” deep (737mm). Individual on-off valve, 100% safety pilot and one heavy duty rack are standard. Oven input is 40,000 BTU’s (11.72kW) per cavity.

Exclusive heat flow over design eliminates, hot spots and gives consistently even oven temperatures. Oven sides, back, deck and door linings coated in porcelain enamel make clean-up easier and ensure long life. Door springs and 100% safety pilot system are located out of heat zone and easily accessible for maintenance.

INSTALLATION

Rating Plate

When corresponding with the factory or your local authorized factory service center regarding service problems or replacement parts, be sure to refer to the particular unit by the correct model number (including the prefix and suffix letters and numbers) and the warranty serial number. The rating plate affixed to the unit contains this information.

We suggest installation, maintenance and repairs should be performed by your local authorized service agency listed in your information manual pamphlet.

In the event you have any questions concerning the installation, use, care or service of the product, write or call our Product Service Department.

This product must be installed by professional personnel as specified. Garland/U.S. Range products are not approved or authorized for home or residential use, but are intended for commercial applications only. Garland / U.S. Range will not provide service, warranty, maintenance or support of any kind other than in commercial applications.

Gas Supply

A.The type of gas for which the unit is equipped is stamped on the data plate located behind the lower front panel. Connect a unit stamped “Nat” only to natural gas; connect those stamped “PRO” only to propane gas.

B.If it is a new installation have the gas authorities check meter size and piping to assure that the unit is supplied with sufficient amount of gas pressure required to operate the unit.

C.If it is additional or replacement equipment have gas authorities check pressure to make certain that existing meter and piping will supply fuel to the unit with not more than ½” water column pressure drop.

NOTE:  When checking gas pressure to be sure that all other equipment on the same gas line is on. A pressure regulator is supplied with model G280-2. A pressure regulator is not supplied as standard equipment with models M1R and M2R, however a 1-1/4” pressure regulator is sold as an option with the original purchase. If you would like to purchase a regulator after original purchase contact your equipment

Page Part # 1382650 Rev 4 (12/07)