Garmin 190-00557-00, 20072009 Connecting Your GPSMAP 76Cx to a Computer, To connect your GPSMAP 76Cx to your computer:, To connect to your computer using a Serial Port connector:

Connecting Your GPSMAP 76Cx to a Computer

You can connect your GPSMAP 76Cx to your computer using either a serial port or USB connector cable.

Note: Fully install the supplied MapSource program, Trip & Waypoint Manager, on your computer before connecting the USB cable to the computer.

To connect your GPSMAP 76Cx to your computer:

1.Lift the USB protective cover from the back of the GPSMAP 76Cx and insert the smaller connector on the USB cable into the matching port.

2.Connect the remaining cable end to your computer's USB port.

Appendix

To connect to your computer using a Serial Port connector:

1.Lift the Serial Port protective cover from the back of the GPSMAP 76Cx and insert the round indexed connector on the cable into the matching port.

2.Connect the remaining cable end to your PC Serial port or other appropriate device.

3.Set your GPSMAP 76Cx interface setting to the appropriate interface format. Refer to Interface Setup on page 35.

Information About USB Drivers

The USB drivers should have been automatically installed when you installed the MapSource program that came with your GPSMAP 76Cx. When you initially connect the GPSMAP 76Cx to a USB port, your computer might prompt you to locate the destination of the drivers for the device. You only need to install the drivers once. After the drivers are installed, your computer always detects your GPSMAP 76Cx when it is connected. USB drivers might be updated periodically. You can find updates at www.garmin.com.

GPSMAP 76Cx Owner’s Manual 5