Getting Started

Batteries, microSD Card, and Lanyard

The GPSMAP 76Cx operates on two AA batteries (not included), which are located in the back of the unit. You can use Alkaline, NiMH, or Lithium batteries. See page 34 for information on setting the battery type.

To install the batteries:

1.Remove the battery cover by turning the D-ring 1/4 turn counter-clockwise and pulling the cover loose.

2.Insert the batteries,

observing the proper

MICRO SD CARD

polarity.

 

3. Reinstall the battery cover.

Remove the batteries from your unit when you do not expect to use the unit for several months. Stored data is not lost when batteries are removed.

microSD card slot

(with microSD card in position for insertion)

To install the microSD card:

1.Remove the battery cover by turning the D-ring 1/4 turn counter-clockwise and pulling the cover loose.

2.Locate the microSD card in the slot below the batteries and press down on the top edge of the card until you feel it click. Then gently allow the card to release.

3.Press down again to install the card, making certain the card is fully in place to prevent damage when reinstalling the battery cover.

To install the lanyard:

1.Place the loop of the lanyard throught the slot at the base of the unit.

2.Route the strap through the loop, and pull tight.

Install the carry lanyard in the slot at the bottom of the unit



GPSMAP 76Cx Owner’s Manual