TIME—the time of day, shown using your selected time format.

TIMER—an alarm that counts down or up in the increments that you set in the Alarms System sub tab.

TURN—the degrees that you must turn left or right to make your direction of travel match your bearing. Steer left (L) or right (R) until this reads 0 to go directly to your destination.

VMG (velocity made good)—the rate of closure to a destination based on your current speed and course.

VOLT—the current battery voltage input.

WTR TEMP (water temperature)—the water temperature at the transducer.

XTE (crosstrack error)—how far off the chosen course you are, measured by your selected distance units. This indicates if you are to the left or right of the course.

Using the Fishfinder 340C > Pausing a Sonar or Flasher Page

Pausing a Sonar or Flasher Page

Use a paused screen to take a better look at sonar returns. The depth continues to update while the page is paused, but the Fishfinder does not show any new sonar data until the Sonar Page resumes scrolling. You might see a discontinuity from where the sonar information stops to where it starts again when you resume scrolling the screen.

To pause and unpause the Sonar or Flasher Page:

From the Sonar or Flasher Page, press PAUSE to stop the scrolling. Press PAUSE again (or QUIT) to resume scrolling.

Fishfinder 340C Owner’s Manual

39