To install the bail mount and unit:

1.Using the bail mount as a template, mark the location of the four mounting holes. Be sure to leave at least 5" (12.7 cm) of clearance behind the unit for the wiring.

NOTE: Mount a 4008/4208/5008/5208 unit 31 1/4" (80 cm), and a 4012/4212/5012/5212 unit 39 3/8" from a magnetic compass to avoid interference.

2.Using an appropriately sized drill bit, drill the pilot holes for your mounting hardware.

3.Secure the bail mount to the surface with your mounting hardware.

4.Loosely attach the mounting knobs to the GPSMAP 4000/5000 series unit.

5.Slide the unit onto the bail mount, and tighten the mounting knobs.

Flush Mounting the GPSMAP 4000/5000 Series Unit

Hardware (included):

•Flush mount template

•Four threaded 4 mm mounting studs

•Four 4 mm flat washers

•Four 4 mm lock washers

•Four 4 mm nuts

Pilot Hole

USE 4 mm DRILL BIT

GPSMAP 4008/4208

unit dimensions: 11 3/16" (284.4 mm) wide x 6 31/32" (176.9mm) high

Tools required (not included):

•Jig saw

•Masking tape

•Scissors

•Drill

•Drill bits—3/8" (6 mm) and 4 mm

•1/16" (2 mm) Allen (Hex) wrench

•4 mm sockets or wrenches

•Center punch and hammer

3/8" (9.5 mm)

6 17/32"

(165.90 mm)

Cut on thiS line

Recommended clearance

for SD card door

1/2"

13 mm

9 5/8" (244.50 mm)

Flush Mount Template Example (not to scale)



GPSMAP 4000/5000 Series Installation Instructions