To attach the enclosed pole mount adapter to the GPS 17:

1.Thread the cable though the pole mount adapter.

2.Align the tab on the pole mount adapter to the notch on the GPS 17.

3.Use the enclosed screws to secure the pole mount adapter to the base of the GPS 17.

Attaching the Pole Mount Adapter to the GPS 17

To mount the GPS 17 with the cable run outside the mount:

1.Place the cable in the vertical slot along the base of the assembled GPS 17 and pole mount adapter.

2.Screw the assembled GPS 17 and pole mount adapter onto a standard 1" O. D. 14 threads-per-inch marine mount (not included). DO NOT overtighten the head. Overtightening the unit may cut the cable.

3.With the GPS 17 installed on the pole mount, fill the remaining gap in the cable exit with a marine sealant.

4.Fasten the pole mount to the boat if it is not already attached.

5.Route the cable away from sources of electronic interference.

To mount the GPS 17 with the cable run through the mount:

1.Position a standard 1" O. D. (Outer Dimension), 14 threads-per- inch marine mount (not included) in the preferred location, and mark the approximate center of the mount.

2.Drill a hole using a 3/4" (19 mm) drill bit for the cable to pass through.

3.Fasten the pole mount to the boat .

4.Slide the cable through the pole mount and screw the assembled GPS 17 and pole mount adapter onto the pole mount.

5.Route the cable away from sources of electronic interference.

Cable run externally

Align Notch

Cable run internally

Attaching the GPS 17 to a Pole Mount

GPSMAP 4000/5000 Series Installation Instructions