The Garmin Marine Network Cable:
•The Garmin Marine Network Cable has a locking ring that secures the cable to the chartplotter or marine network device. Because of the size of this locking ring, it is not connected to the network cable at the factory to make it easier to install on your boat.
•Once the cable is run to the chartplotter or network device, snap the locking ring together around the connector and insert the rubber washer as indicated on the instructions packaged with the cable.
Sample Garmin Marine Network Setups:
GPS 17
Garmin GPSMAP 4000/5000 | Garmin GPSMAP 4000/5000 |
Series chartplotter | Series chartplotter |
Additional
NMEA
devices
Marine Network with Two Chartplotters
NMEA 0183 cable
Marine network
cable
Garmin Marine Radar
GDL 30/30A XM Weather unit | GSD 22 Sounder Unit |
x x xxx
GPS 17
x
xxxxxxxxxxxxxxxxxxxx
To transducer
Garmin GPSMAP 4000/5000 | Garmin GPSMAP 4000/5000 |
Series chartplotter | Series chartplotter |
Additional
NMEA 0183
devices
Extended Marine Network With Two Chartplotters
Note: Every device connected to the Garmin Marine Network must be connected to the boat’s power supply. These diagrams only show the network connections, and do not show the power connections. Wire each device according to its installation instructions.
GPSMAP 4000/5000 Series Installation Instructions |