Manage the Gateway
Administration > Diagnostics
Administration diagnostics allow you to check the status of your Internet connection by using a Ping test.
Select the Diagnostics tab to open the Administration Diagnostics page.
Use the descriptions and instructions in the following table to configure the diagnostics feature on the gateway. After you make your selections, click Save Settings to apply your changes or Cancel Changes to cancel.
| Section | Field Description | |
| Ping Test |
|
|
| Ping Test Parameters | Ping Target IP | |
|
| The IP address that you want to ping | |
|
| Ping Size | |
|
| The size of the packet you want to use | |
|
| Number of Pings | |
|
| The number of times you wish to ping the target device | |
|
| Ping Interval | |
|
| The time period (milliseconds) between each ping | |
|
| Ping Timeout | |
|
| The desired time period (milliseconds) of the timeout. If no | |
|
| response is received within this ping period, the ping test is | |
|
| considered a failure | |
|
| Start Test | |
|
| To start a test, complete the following steps. | |
|
| 1 Click Start Test to begin the text. A new page opens and | |
|
| displays a summary of the test results. | |
|
| 2 Click the Save Settings to save the test results or click | |
|
| Cancel Changes to cancel the test. | |
|
|
|
|
84 |
| 4021192 Rev A | |
