102
Chapter 7: Adding or Replacing Components
www.gateway.com
5Set any jumpers on the new drive to match the old drive. See the drive
documentation for further instructions.
6Slide the new drive in, then slide the release lever toward the inside of the
case.
7Reconnect the drive cables using your notes from Step 2. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin1
on the drive (typically on the side farthest from the power supply
connection). For more information, see the drive documentation.
8Close the case by following the instructions in “Closing the case” on
page 95.