
CHAPTER 4: Installing Components
The Array List opens showing the disks in the array.
7To make the array bootable, press B (Set Boot) to change Boot No to Boot Yes.
8Exit the RAID Configuration utility and reboot the server.
Installing memory
Caution
Use only 667 Mhz compliant,
The system board supports 4 DDR2 667 MHz vertical DIMMs to provide up to 8 GB of memory with ECC support. The 667 MHz differential memory clocks are driven by the AMD processor with length matching and impedance controlled through all the DIMM slots. Supported DIMM sizes include 256 MB, 512 MB, 1 GB, and 2 GB.
The BIOS configures the memory controller to run in either single channel or dual channel mode, depending on the following:
•If one or more fully populated DIMM banks are detected, the memory controller will run in dual channel mode.
•If only a single DIMM is present, the memory controller will run in single channel mode. DIMM banks must be populated using the following guidelines:
•DIMM banks must be populated in order, starting with Bank 0.
•Dual rank DIMMs must be populated before single rank DIMMs.
Channel B DIMM 2
Channel A DIMM 2
Channel B DIMM 1
Channel A DIMM 1
34