
www.gateway.com
8Remove the seven screws securing the system board to the case.
Screw | Screw |
Screw | Screw |
Screw | Screw |
Screw
9Pull the system board away from the case and carefully remove it, then place it in a
10Insert the new system board into the case, aligning the holes in the board with the threaded standoffs on the side of the case.
11Secure the system board to the case with the seven (7) screws you removed previously.
12Reinstall the memory by following the instructions in “Installing memory” on page 34.
13Reinstall the processor and heatsink by following the instructions in “Replacing the processor” on page 38.
14Connect the power and data cables.
15Reinstall the expansion cards by following the instructions in “Installing PCI expansion cards” on page 35.
16Follow the instructions in “Closing the server case” on page 24.
17Turn on your server.
18Press F2 when the Gateway logo screen appears during startup. The BIOS Setup utility opens.
19Check BIOS settings to make sure that they detect the server’s new hardware, then save your changes (if any) and close the BIOS Setup utility.
45