
CHAPTER 4: Installing Components
8When the processor is oriented correctly and in place, press it firmly into the socket, rotate the retention lever into place until it clicks.
Caution
The heatsink has Thermal Interface Material (TIM) located on the bottom of it. Use caution when you unpack the heat sink so you do not damage the TIM. If you are reusing the original heatsink, make sure that the TIM on the bottom of the heatsink is not damaged. If the TIM is damaged, you should remove the old TIM, then apply new TIM to the bottom of the heatsink.
9Place the heatsink down onto the processor, then gently tighten the heatsink retaining screws to secure it into place.
10Follow the instructions in “To close the server case:” on page 24.Replacing a power supply module
Warning
The power supply modules in this server contain no
Your server comes with
If your server uses the optional

2If you have two power supply modules, examine the LED indicators on the back of each power supply module to identify the failed module. The power supply module has failed if the orange (right) LED indicator is on.
Power supply handle
Power supply fault LED
Power connector
Power supply latch
Power on LED
3Unplug the power cord from the failed power supply module.40