Using Your Gateway Flat Panel Monitor

www.gateway.com

3Adjust the height tension screw so raising and lowering forces are equal. After the forces are equalized, turn the tension screw clockwise 2 to 4 turns to slightly decrease the lifting tension.

4For optimum viewing, adjust the height so the top of monitor is about 1 inch below eye level.

Adjusting tilt (vertical viewing angle) tension

To test and adjust tilt tension:

1Tilt the monitor back and forth through its entire tilt range. If it does not stay in place or if movement in one direction is stiff, the tilt tension needs adjustment.

2Pull the black rubber cover away from the top of the stand, then hold it back with one hand.

Increase tilt tension (clockwise)

Decrease tilt tension (counter-clockwise)

3To increase tilt tension, turn the screw clockwise with a Phillips screwdriver. To decrease tilt tension, turn the screw counter-clockwise. Adjust until the monitor stays in place and the up and down tilting tensions are equal.

6