www.gateway.com

Diskette drive

Solving problems

The diskette drive is not recognized

■Shut down and restart your computer.

You cannot save a file to diskette or you see the message “disk is full or write-protected”

■Make sure that the write-protection tab on the upper-right corner of the diskette is down (unprotected).

■Delete unnecessary files on the diskette and try again.

■Make sure that the diskette you are using is IBM-compatible.

■Try a different diskette. Occasionally diskettes are flawed and cannot be read by the diskette drive.

■Run Error-checking on the diskette. For more information, see “Checking the hard drive for errors” on page 129. If errors are detected and corrected, try using the diskette again.

You see a “Access Denied” or “Write protect” error message

■Move the write-protection tab in the upper-right corner of the diskette down (unprotected).

■The diskette may be full. Delete unnecessary files on the diskette and try again.

■Make sure that the diskette you are using is IBM-compatible.

■Try a different diskette. Occasionally diskettes are flawed and cannot be read by the diskette drive.

You see a “Disk is full” error message

■Delete unnecessary files on the diskette.

■Try a different diskette. Occasionally diskettes are flawed and cannot be read by the diskette drive.

■Run Error checking on the diskette. For more information, see “Checking the hard drive for errors” on page 129.

You see a “Non-system disk” or “Disk error” error message

■Eject the diskette from the diskette drive, then press ENTER.

■Make sure that the diskette you are using is IBM-compatible.

The diskette drive LED is lit continuously

■Remove the diskette from the drive. If the light stays on, try restarting your computer.

141