GD Commerce EDA-M350, EDA-M300, EDA-M100, EDA-M200, EDA-M150 manual Hardware Specification

Page - 1 Windmill￿

Hardware Specification￿

In order to run Windmill or PanCom software the following system requirements must be satisfied:￿ 1.1 PC Requirements￿

Pentium Processor running Windows 95 or later￿

The display must be run in a resolutions mode of 800 x 600 or greater.￿ Serial port Com1, Com2 or Com3￿

As some software takes priority over the serial ports, it must be ensured that any such software has been￿ terminated if using the same serial port as used by this software.￿

1.2 Fire Alarm Control Panel Requirements￿

This programming software works for the Millennium range of control and booster panels including the: -￿ EDA-M100￿

EDA-M150￿

EDA-M200￿

EDA-M300￿

EDA-M350.￿

All versions of software fitted in panels are supported.￿ 1.3 Additional Equipment Required￿

In addition to the PC and control panel you will require a set of programming leads EDA-Q592. These￿ leads either plug into the front of the control panel using a 5 pin din connector or through the module port, a 20 way IDC connector labelled ‘Module Port’ on the processor PCB on the inside of the panels door.￿ The leads can not be copied easily as a printed circuit board is fitted inside the 9 way D Type connector￿ that plugs into the PC.￿

2.0 Introduction and Version Control￿

This section details any changes to software and manuals for the Windmill programming software￿

3.0 Navigating the CD￿

The supplied CD contains all the necessary set-up files for both Windmill and PanCom software.￿ Also included on this disk are various other features, including product datasheets, manuals and￿ photographs. Details on installing this software as well as accessing the other features included on￿ the disk are detailed in the following section:￿

3.1 Disk Structure￿

As can be seen the CD is made up of 7 main directories. The contents of each directory is detailed as fol-￿ lows:￿

datasheets: technical sheets for the EDA product range.￿

eda: installation files for DOS based software for panels.￿

edadet: installation files for DOS based software for device programming.￿

manual: user manuals for the EDA product range.￿

pancom: installation files for WINDOWS based panel downloading.￿

3_5_disk: installation files for transfer to 3.5" floppy disk.￿

photos: sales photos for the EDA product range.￿

jpg: photos in *.jpeg file format (lower resolution)￿

tif: photos in *.tif file format (higher quality)￿

windmill: installation files for WINDOWS based panel messages and options.￿

3_5_disk: installation files for transfer to 3.5" floppy disk.￿

Installation of program files along with viewing of the other resources will be dealt with in the following sec-￿ tions:￿

GD Systems