GE 164D2966P118 movable Oven Bottom, Painted Surfaces, To remove, To replace the oven bottom

Models: 164D2966P118

1 28
Download 28 pages 47.47 Kb
Page 23
Image 23
movable Oven Bottom

movable Oven Bottom

The oven bottom can be removed to make cleaning easier.

To remove:

1. Grasp the oven bottom at finger slots on each side.

RWO-Y

 

2.Lift front edge of the oven bottom enough to raise th~ tabs from s1[)[s in the front frame.

3.Push the oven bottom back tibout To replace the oven bottom:1 /4” to release the tltinge from the front frame, then pull out.

To replace the oven bottom:

1.Slide the oven bottom into the oven so rear tabs fit into slots in the rear wall of the oven.

2.Grasp the oven bottom at finger slots and push it back and then down to hook the flange under the front frame.

3.Fit the front tabs into slots in front frame.

Finger slot

The oven bottom has a porcelain enamel finish. To make cleaning easier, protect the oven bottom from excessive spillovers. This is particularly important when baking a fruit pie or other foods with

‘~ tic id content. Hot fruit fillings or foods that are

.ic in content such as milk, tomato or sauerkraut and sauces with vinegar or lemon juice, may cause pitting and damage to the porcelain enamel surface,

To protect the oven bottom surface, place a

piece of aluminum foil slightly larger than the baking dish on the shelf below to catch any boilovers. It should not completely cover the shelf as this would cause uneven heat in the oven. Aluminum foil should not be placed on the oven bottom.

If a spillover does occur on the oven bottom, allow the oven to cool first. Remove the oven bottom for easier cleanup and to prevent damage to the continuous cleaning oven coating.

Frequent wipings with mild soap and water (particularly after cooking meat) will prolong the time between major cleanings. Rinse thoroughly. Soap left on the oven bottom can cause stains.

For heavy soil, use a mild abrasive cleaner and follow label instructions, using a thin layer of cleaner. Use of rubber gloves is recommended. Wipe or rub lightly on stubborn spots. A commercial oven cleaner may also be used, following package directions.

Painted Surfaces

Painted surfaces include the control panel and drawer front. Clean these with soap and water or a vinegar and water solution. Do not use commercial oven cleaners, cleansing powders, steel wool or harsh abrasives on any painted surface.

((c]ntitzL4ed fIe.xt page)

23

Page 23
Image 23
GE 164D2966P118 warranty movable Oven Bottom, Painted Surfaces, To remove, To replace the oven bottom