WALL MOUNT INSTALLATION
2
1. Plug the short telephone line cord into the
PHONE LINE jack on the back of the base 15 and connect the other end to a wall jack.
2.Plug the power supply cord into the 9V DC jack on the base and plug the power
supply into an AC outlet.
3. Feed the short line cord through the notch |
|
at the top of the wall mount bracket so that | 4 |
it comes through the square opening on | 3 |
the bracket. Then feed the power supply cord through both the top and bottom notches on the bracket.
4.Attach the wall mount bracket by putting the tabs into the slots on the top of the unit and then snap the tabs at the bottom of the wall mount bracket into place.
5.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (Wall plate not included.)
6. Raise the base antenna. | 8 |
|
7.Set the TONE/PULSE switch to TONE for
8.Select RINGER ON or OFF (on the side of handset). When you select OFF, the handset doesn’t ring.
9.Place handset in the base to charge for 12 hours. The CHARGE/IN USE light comes on indicating that the battery is charging.
If you don’t charge the battery properly (for 12 hours) when you first set up the phone, the battery’s
8
