GE 200D2463P002 Installation Instructions REVERSING THE DOOR SWING CONT, Transfer Door Stops

Installation Instructions

REVERSING THE DOOR SWING (CONT.)

5TRANSFER CENTER HINGE

BRACKET TO THE LEFT

Remove the center hinge bracket by removing the three screws.

NOTE: Keep these screws with the hinge bracket. They are long screws and will be used when installing the hinge on the other side.

You will need to remove the color-matched cap from the screw head before you can remove the screw. Use the edge of a thin flat blade to gently pry the caps off the screw heads. (A putty knife works well for this.) Cover the blade with tape to prevent scratching the paint.

Remove the mullion cover from the left side using the thin flat blade. Assemble it to the right side.

Remove the screw from the center left side of the cabinet. Screw it into the holes on the right side.

Place the center hinge bracket over the holes at the center left side of the cabinet. Insert and tighten the three long screws.

Replace the cap by snapping it over the screw with your finger.

Screw Cap

Mullion Cover

6TRANSFER DOOR STOPS

On each door, move the metal door stop from the right to the left.

Move any screws from the left to the right.

7TRANSFER REFRIGERATOR

DOOR HANDLE TO THE RIGHT

To remove the handle: Remove the plug button by carefully prying under the edge with a putty knife. Remove the exposed screw holding the handle.

Handle Plug

Remove the two screws holding the handle to the top of the door.

Long Handle Short Handle

Short

Screw

Hole	Handle
	Plug
	Handle
	Plug
Pin

After removing the handle: Move the small plug buttons from the top right side of the door top and insert them into the holes on the opposite side.

Small Plug

Buttons

Move the large plug button from the left edge of the door and insert it into the hole on the opposite side.

Plug Button

20