GE 2800 manual Zoneline Features

Zoneline® Features

		AZ	AZ	AZ
		2800	800	5800
Enhanced Dehumidification — Dry Air 25		Optional	N/A	N/A
Cooling EER Range (230 Volts/265 Volts)		10.2 - 12.7	10.0 - 12.7	10.2 - 13.0
Heating COP Range (230 Volts/265 Volts)		N/A	.2 - 3.6	.2 - 3.6
Heat Source — Electric Resistance Heat		Standard	—	—
Heat Source — Heat Pump With Selectable
	Full Time or On Demand Simultaneous/
	Supplemental Resistance Heat	—	Standard	Standard
Staged Heating		—	 Stage	 Stage
Universal Heater — UPC*		Standard	Standard	Standard
Unit Controls		Rotary Knobs	Rotary Knobs	Touch Pad
Electronic Temperature Selection
(Slews Up & Down) with Digital Display		—	—	Standard
Unit Diagnostics		—	—	Standard
Highly Featured Microprocessor Controls		Standard	Standard	Standard-Plus
Electric Resistance Heat Lock-Out (above 46°F)		—	Standard	Standard
Automatic Emergency Heat		—	Standard	Standard
Heat Pump Defrost System		—	Reverse Cycle	Reverse Cycle
High Temperature Operation Protection		—	Standard	Standard
Quick Heat Recovery		—	Standard	Standard
Temperature Boost			Selectable	Selectable
Service Indicator		—	—	Temp Display Blinks
Fan Motors — Permanently Lubricated		2	2	2
2-Speed Outdoor Fan		Standard	Standard	Standard
Indoor Fan Speed Selections — HIGH/LOW		Standard	Standard	HIGH/LOW/AUTO
Fan Only Setting — HIGH/LOW		Standard	Standard	Standard
Fan Cycle Switch		“Smart Fan”	“Smart Fan”	“Smart Fan”
Constant-Run Fan		Selectable	Selectable	Selectable
Rotary Compressor		Standard	Standard	Standard
Automatic Compressor Restart Delay		Standard	Standard	Standard
Freeze Sentinel™		Standard	Standard	Standard
Heat Sentinel		Standard	Standard	Standard
Indoor Coil Frost Control		Standard	Standard	Standard
Transfer Fan Connections		Standard	Standard	Standard
7-Step Electronic Temperature Limiting		Standard	Standard	Standard
Remote Control Capability with Wall Mounted Thermostat		Standard	Standard	Standard
Central Desk Control Capability		Standard	Standard	Standard
Energy Management System Interface with Load Shedding Option		Standard	Standard	Standard
Reversible Indoor Air Louvers 40º/50º		Standard	Standard	Standard
Up-Front Filters		Standard	Standard	Standard
Easy-Clean Air Discharge Area		Standard	Standard	—
Concealed Manual Vent Control		Standard	Standard	Standard
Ducted Installation Capability		RAK6052	RAK6052	—
Corrosion Protection (Standard on Dry Air 25)		Optional	Optional	Standard
Internal Condensate Removal (ICR) (Factory Installed Option.
Cannot be used in Corrosion Areas.)		N/A	Optional	Optional

*UPC — Universal Power Cord Connection (See pages 42 and 55).

265-volt units must be connected in a manner to meet National Electrical Code and all local codes.