Installation Instructions
STEP 10 INSTALL 1/4″ FRAMED PANELS
Right hand models shown. Use the same instructions for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS, GO TO STEP 10A.
Handle | Door Trim |
Trim |
|
Refrigerator
Door
Use Front Holes to Secure Trim
Use Rear Holes
to Secure Handle
Standard supplied handle shown
in 1/4″ panel position.
Install door and drawer panels:
•Open door to 90°. Remove the 4 Phillips head screws from the door handle.
•Remove handle. Retain all screws.
•Remove 4 screws holding trim, lift off trim. Retain screws.
•Slide framed panel into the door trim.
•There are two sets of holes in the handle side trim. Replace handle side trim by installing the original screws in the FRONT screw holes.
•Secure the handle to the door using the REAR screw holes.
•Follow the same procedures to install the drawer panel.
14