GE A016-1CG manual Configuring the C3000/C0300 DPA A016SP Table, A016SP Table Fields

Chapter 12: Configuring the C3000/C0300 DPA A016_SP Table

This chapter describes entries the user must provide in the A016_SP table found in the C3000/C0300 DPA configuration.

The A016_SP table provides information for setpoints, which are used by the C3000/C0300 DPA. The table contains one record for each setpoint to customize the usage of the point. The fields contained in the table are described in the following table:

			Table 13 A016_SP Table Fields
	Field		Range	Description
System point		If System point set to Analog		If System point is set to Analog Output this field is the system analog
				output point number (zero-based), which is used as the destination for a
			Output:
				LRU Setpoint. The high entry limit is confined to the highest system
			Any valid system Analog
				analog output point configured in the system.
			Output point or Undefined (-1).
			If System point set to Digital	If options set to Digital Output this field is the point number of the first of
			Output:
				twelve contiguous system control output points, which are used as the
			Any valid system Digital Output
				destination for a LRU Setpoint. The high entry limit is confined to 11 less
			point or Undefined (-1).
				than the highest system control output point configured in the system.
Options			If System point set to Analog	Specifies the setpoint output to either Analog Output or Digital Output’s
			Output:
				output in either 2’s complement, sign magnitude, or unipolar format.
			AO: 2’s complement
			AO: sign/magnitude
			AO: unipolar
			If System point set to Digital
			Output:
			DO: 2’s comp. D20 Latch
			DO: sign/mag D20 Latch
			DO: unipolar D20 Latch
			DO: 2’s comp. Ext Latch
			DO: sign/mag. Ext Latch
			DO: unipolar Ext Latch

General A016-1CG-1.00-2

Full 23