GE ABN12 operating instructions Through-the-Wall Installation, Top to the wooden frame

	0
	●
Through-the-Wall Installation	14

,1	d!			,
				II
,1	II
If---- -		s------ -
		*Q	-1
		Q+	~
		%*
		ig	?-
iv	.
		--------!I
!’
:@----------,1--				;:
II	:!

1Remove the front grille insert, air filter and the front grille.

2 Remove the two grounding/ anti-theft screws from either side of the case.

1 Place the case in the wall opening with a 1/4” minimum tilt to the outside.

2 Secure the bottom rail, case sides

and top to the wooden frame

using 1” long ##1Oscrews.

3 Slide the air conditioner from the case by pulling on the bottom lip of the air conditioner while holding the case.

For specilic instructions, refer to Window Installation Instructions.

NOTE:

Drill holes in the case sides and top, if necessary for proper installation. If the frame is oversized, use shims to prevent cabinet distotiion.

Caulk	the sides and		the	top on	2	Install wood		trim molding,	if
the outdoor		side of	the	case. On		desired,	on	the inside wall
the roomside,		caulk	around the			around	the case.
bottom rail to prevent moisture
from getting through to the
interior wall.
								Plaster
Brick	veneer							line
Lintel	angle							Trim
(if required)
								molding
Caulking								(if desired)
						0		Roomside
				Holes	for	#10		Grounding/
				1“ long		o		anti-theft	screw
				wood screws
						o	0	Caulking
								(between
							k
								bottom	rail
								and flashing)
Flashing
Caulking								1w’
								min.

13