GE AEW08, AET05, AEW06, AEW05 installation instructions Consumer Support, Instructions

ge.com

Safety

Remote Control

■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.

■The remote control signal has a range of up to 20 feet.

■Make sure nothing is between the air conditioner and the remote control that could block the signal.

■Make sure batteries are fresh and installed correctly as indicated on the remote control.

Instructions

Cool Mode

Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling. Use the Temperature Increase ▲ / Decrease ▼ pads to set the desired temperature between 64°F and 86°F in 1°F increments.

An electronic thermostat is used to maintain the room temperature. The compressor will cycle on and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.

NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to start and cooling to begin.

Cooling Descriptions

For Normal Cooling—Select the Cool mode and High or Med fan with a middle set temperature.

For Maximum Cooling—Select the Cool mode and High fan with a lower set temperature.

For Quieter & Nighttime Cooling—Select the Cool mode and Low fan with a middle set

temperature.

Operating Instructions Installation

Energy Saver Mode

Controls the fan.

ON—The fan will cycle on and off with the compressor. This results in wider variations of room temperature and humidity. Normally used when the room is unoccupied. NOTE: The fan may continue to run for a short time after the compressor cycles off.

OFF—The fan runs all the time, while the compressor cycles on and off.

Instructions

Fan Only Mode

Use the Fan Only Mode at Low, Med or High fan speed to provide air circulation and filtering without cooling. Since fan only settings do not provide cooling, a Set temperature cannot be entered. The room temperature will appear in the display.

NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.

Troubleshooting Tips

Auto Fan Speed

Set to Auto fan speed for the fan speed to	NOTE: Auto Fan Speed cannot be used when in the
automatically set to the speed needed to provide	Fan Only Mode.
optimum comfort settings with the set temperature.
If the room needs more cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease.

Power Outage Recovery Feature

In the case of a power outage or interruption, the	feature was set, it will resume countdown. You may
unit will automatically re-start in the settings last	need to set a new time if desired.
used after the power is restored. If the Delay 1–24hr	5

Consumer Support