Instructions
Horizontal sliding window installation instructions.
Read completely, then follow
Safety
3
Install the Window Track Gasket or Seal
Operating Instructions
For sliding window installation, fold and fit one of the foam gaskets into the window track. This may require cutting the ends of the gasket to make it fit properly in the track. Discard the bottom seal; it is not needed.
For casement window installation, remove the backing from the bottom seal and apply it to the horizontal inside face edge of the window frame. Discard the foam gaskets; they are not needed.
Window
jamb
Foam gasket
Window track
Sliding WindowBottom seal
Casement WindowCare and Cleaning
4
Prepare the Window and the Support Assembly
A | Loosely attach the support platform to | C |
| the support angle using 2 Type A screws, |
|
|
| |
| washers and nuts. |
|
BAttach the leveling bolt and nut.
Type A screws
Measure and mark a line 81⁄4″ (for sliding windows) or 81⁄8″ (for casement windows) from the window jamb. Center the support assembly on the window track. Attach the support platform to the window stool using 4 Type D screws.
NOTE: For casement window installation, the back edge of the support platform must butt flush against the window frame face. Modify window as needed.
Instructions
Washers
Support platform
Depending on the window track material, you may need to drill holes in the window track through the existing holes in the support assembly to secure the screws.
Installation
Nuts | Support angle |
|
Leveling bolt and nut
81⁄4″
(sliding
window)
81⁄8″
(casement
window)
Troubleshooting Tips
The window track may not allow the air conditioner to tilt toward the outside and will keep it from draining properly. To adjust for this, attach a piece of wood to the stool.
Wood
1/16″ higher | Stool |
than track |
D
Pull the support angle against the outside wall and tighten the screws on top of the support platform. Adjust the leveling bolt so the support platform is installed with a slight tilt to the outside. Use a level; about 1/3 bubble will be the correct slant to the outside. Tighten the nut.
Consumer Support
WOOD PIECE—
WIDTH: 2″
LENGTH: Long enough to fit inside window frame.
THICKNESS: To determine the thickness, place a piece of wood between the stool and the support platform to make it 1/16″ higher than the top of the window track.
Attach securely with nails or screws provided by
10the installer.
A filler block is
recommended for
homes with vinyl or
aluminum siding