Preparing to install the air conditioner.
Read these instructions completely and carefully.
Before You Begin
Safety Instructions
NOTE TO INSTALLER: Leave these instructions with the air conditioner after installation is completed.
NOTE TO CONSUMER: Keep Owner’s Manual and Installation Instructions for future use.
CAUTION:
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
Do not change the plug on the power cord of this air conditioner.
Aluminum house wiring may present special
IMPORTANT NOTES:
For personal safety, this air conditioner must be properly grounded.
It is important to have the wall outlet and circuit checked by a qualified electrician if there is any doubt as to whether a proper ground exists.
Follow National Electric Codes (NEC) and/or local codes and ordinances.
Power cord may include a current interrupter device. A test and reset button is provided on the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not trip or if the RESET button will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.
Operating Instructions Care and
Electrical Requirements
Cleaning
Some models require
The
Some models require
or apartment wiring circuits, which could cause a possible fire hazard from overheating wires.
Installation Instructions
Tools You Will Need
■ Screwdrivers | ■ Pencil |
■ Ruler or tape measure | ■ Level |
■ Scissors or knife | ■ Drill and 1/8″ bit |
Before Installing the Air Conditioner
AOpen the inlet grille and remove the filter. See the Air Filter section.
B | Secure the front grille frame with the two |
| screws packed with the Owner’s Manual. |
| |
| Replace the filter and close the inlet grille. |
C |
Inlet grille | 7 |