GE AJCQ 08 Fan Switch, Operating, Temperature Limiting, Cleaning Installation, Vent Control

Models: AJCH 12 AJES 10 AJCH 10 AJES 12 AJCQ 06 AJES 06 AJEH 12 AJES 09 AJCS 12 AJCS 09 AJCQ 08 AJCQ 10 AJCS 06 AJCS 08 AJCS 10 AJCH 08 AJCQ 12 AJES 08 AJHS 10 AJHS 08

1 76
Download 76 pages 54.77 Kb
Page 9
Image 9
Operating

ge.com

Fan Switch

To reach the fan switch(es) remove the front grille.

Safety Instructions

On Heat/Cool and Heat Pump models, the fan switch levers are located in holes accessed through the control box. The top switch is for COOL settings and the bottom switch is for HEAT settings.

Use a small screwdriver to change the setting. The unit is shipped from the factory set in the CONT setting for COOL and in the CYCLE setting for HEAT.

or

(Depending on model)

Operating

Cool only models have a rocker switch on the front of the control box.

When set at CYCLE (down) the fan cycles on and off when cooling. When set at CONT (continuous, up) the fan runs all the time, providing a more balanced temperature. The unit is shipped in the CONT setting.

Instructions Care and

Temperature Limiting

Limiting the maximum and minimum settings prevents users from turning the control to the extreme heat or cool positions.

The normal range of the temp control is approximately 60°F to 85°F. The control range may be narrowed by the use of the temperature limiting screws located behind the control panel.

Limits

Limits

heat

cool

temp

temp

Cleaning Installation

Each position equals approximately 3°F.

Vent Control

The vent control is located behind the front grille on the right side of the air discharge area. When set at CLOSE, only the air inside the room will be circulated and conditioned. When set at OPEN, some inside air is exhausted outside.

To open or close the vent:

1.Remove the front grille.

2.Remove the vent card screw.

3.Remove vent card, turn it over and replace it by locating rear hole in card over locating pin inside air discharge and reattaching screw at front.

The unit leaves the factory set at the CLOSE position.

Locating hole

Locating hole

Screw hole

Screw hole

OPEN position

CLOSE position

(Mesh end toward back)

(Mesh end toward front)

Instructions Troubleshooting Tips

Air Direction

Horizontal louvers

Remove the front

 

on the front grille

grille to adjust the

 

let you control the

vertical louvers

 

air direction up

side-to-side to

 

and down.

direct the air left

 

 

or right.

9

 

 

Consumer Support

Page 9
Image 9
GE AJCQ 08 Fan Switch, Operating, Temperature Limiting, Cleaning Installation, Vent Control, Air Direction, ge.com