GE AMH10 Preparing to install the air conditioner, Before You Begin, Electrical Requirements

Preparing to install the air conditioner.

Read these instructions completely and carefully.

Before You Begin

Safety Instructions

NOTE TO INSTALLER: Leave these instructions with the air conditioner after installation is completed.

NOTE TO CONSUMER: Keep this Owner’s Manual and Installation Instructions for future use.

IMPORTANT NOTES:

For personal safety, this air conditioner must be properly grounded.

It is important to have the wall outlet and circuit checked by a qualified electrician if there is any doubt as to whether a proper ground exists.

Follow National Electric Codes (NEC) and/or local codes and ordinances.

CAUTION:

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

Do not change the plug on the power cord of this air conditioner.

Aluminum house wiring may present special problems—consult a qualified electrician.

Operating Instructions

Electrical Requirements

This model requires a 115/120-volt a.c., 60 Hz grounded outlet protected with

a 15-amp time delay fuse or circuit breaker.

The 3-prong grounding plug minimizes the possibility of electric shock hazard. If the wall outlet you plan to use is only a 2-prong outlet, it is your responsibility to have it replaced with a properly grounded 3-prong wall outlet.

Tools You Will Need

■ Phillips-head screwdriver	■ Pencil
■ Ruler or tape measure	■ Level
■ Scissors or knife	■ Drill

7

Installation Instructions Troubleshooting Tips

Customer Service