Operating Instructions Safety Instructions
About the controls on the air
Features and appearance will vary.
Low | Med | High |
| CIRCULAIRE | ENERGY | |||
Fan | Fan | Fan |
| On | SAVER On | |||
| ||||||||
On | On | On |
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cool
Mode On
Fan |
|
|
| Timer |
Only |
|
|
| On |
| ||||
On |
|
|
|
|
|
|
| ||
|
|
|
|
|
Air Conditioner Controls | Remote Control |
Support Troubleshooting Tips Installation Instructions
ON/OFF
Turns air conditioner on and off.
Display
MODE
Use to set the air conditioner to COOL or FAN.
Increase ▲ /Decrease ▼ Pads
Use to set temperature when in COOL mode.
FAN
Use to set the fan speed at LOW, MED or HIGH.
CIRCULAIRE
Turn on to provide continuous
For fixed
ENERGY
This switch must be set at OFF in order to use the fan settings (on the mode control).
TIMER
To cancel the timer, press the TIMER pad until the display time disappears.
SLEEP
Press to set the air conditioner to run for 8 hours before it automatically shuts off.
When the SLEEP pad is pressed, SLEEP scrolls across the display for approximately 15 seconds, then shows the time remaining.
One hour after the sleep timer is set, the set temperature will automatically increase 1°F.
To cancel the sleep mode, press the SLEEP pad a second time.
Note: The sleep timer will be cancelled if the TIMER, ENERGY SAVER or MODE pad is pressed.
Remote Control Signal Receiver
Consumer
Remote Control
■To ensure proper operation, aim the remote control at the signal receiver on the air conditioner.
■The remote control signal has a range of
4up to 21 feet.
■Make sure nothing is between the air conditioner and the remote control that could block the signal.
■Make sure batteries are fresh and installed