Installation Instructions
STEP 12 CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
• Slide compression nut, then ferrule over end of water line.
• Insert water line into 90° elbow.
• Slide ferrule against |
| Hot Water | |
elbow and secure with | 90° Elbow | ||
Supply Line | |||
compression nut. | |||
|
|
Figure BB
IMPORTANT – Check to be sure that door spring does not rub or contact the fill hose or water supply line. Test by opening and closing the door.
DRAIN LINE INSTALLATION
•Connect drain line to air gap, waste tee or disposer using either previously determined method.
Method 1 – Air gap with waste tee or disposer Insert the drain hose to air gap a s shown.
Waste Tee Installation | Disposer Installation |
Figure EE
Method 2 – Drain Hose Routing
Route the drain hose of the dishwasher to a minimum height of 32" from the floor with the supplied hanger as shown.
STEP 13 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The molded end of the drain hose will fit 5/8" through 1" diameter inlet ports on the air gap, waste tee or disposer.
•Determine size of inlet port
•Cut drain hose connector on the marked line, if required, to fit the inlet port.
Cutting Lines
1" 3/4" 5/8"
Figure CC IMPORTANT: Do not cut corrugated portion of hose
•If a longer drain hose is required, add up to 42" of length for a total of 10' to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the
connection with����������
hose clamps.�������
Figure DD����������
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR PROPER DRAIN OPERATION.
| 32" |
| 32" | |
| Min. |
| ||
18" | 18" | Min. | ||
| ||||
Min. |
| Min. |
|
Waste Tee Installation | Disposer Installation |
Figure FF |
|
IMPORTANT Either one of the above methods must be used or dishwasher will not operate properly.
IMPORTANT – When connecting | ������ | |
drain line to disposer, check to be sure | ||
������ | ||
that drain plug has been removed. | ���� | |
DISHWASHER WILL NOT DRAIN IF |
| |
PLUG IS LEFT IN PLACE. |
|
Tip: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer.
10
