Installation Instructions
STEP 2 ADJUST LEVELING LEGS
•Move the dishwasher close to the installation location and lay it on its back.
Adjust to
Installation
Height
Figure I
•Measure installation height and dishwasher height. Extend leveling legs out from the dishwasher base, 1/2" less than installation height.
STEP 3 REMOVE TOEKICK
• Remove the 4 toekick screws. Lift off the 2 piece toekick.
Remove
4 Toekick
Screws
Figure J
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
Use Power Cord Kit WX09X70910, available for purchase from an authorized GE Appliance Dealer. The power cord and connections must comply with the National Electrical Code, Section 422 and/or local codes and ordinances.
• Maximum power cord length is 6'.
AB Check That White, Black and
Remove | Green Dishwasher Wires Are Threaded | |
Junction Box |
| Thru Hole in Back |
Cover |
|
|
| Ground | White |
|
| Black |
DUse UL Listed
Wire Nuts
C
Insert Power
Cord Wires Thru
Figure KStrain Relief
and Tighten
•Connect incoming power cord white (or ribbed) to dishwasher white, black (or smooth) to black and ground to dishwasher green wire. Use UL listed wire nuts of appropriate size.
•Replace junction box cover. Be sure wires are not pinched under the cover.
STEP 5 INSTALL 90° ELBOW
•Wrap 90° elbow with thread seal tape.
•Install a 90° elbow onto the water valve.
Fill
Hose
90° Elbow
Water
Valve
Bracket
Thread
Seal Tape
Figure L
•Do not over tighten 90° elbow, water valve bracket could bend or water valve fitting could break.
•Position the end of the elbow to face the rear of the dishwasher.
6
