FT-950
Operating Manual
The torque (drag) of the Main Tuning Dial knob may be adjusted according to your preferences. Simply hold down the rear skirt of the knob, and while holding it in place rotate the knob itself to the right to reduce the drag or to the left to increase the drag. Available adjustment range is 120°.
Resetting the Microprocessor
Resetting Memories (Only)
Use this procedure to reset (clear out) the Memory channels previously stored, without affecting any configuration changes you may have made to the Menu settings.
1.Press the front panel’s [POWER] switch to turn the transceiver off.
2.Press and hold in the [A>M] button; while holding it in, press and hold in the front panel’s [POWER] switch to turn the transceiver on. Once the transceiver comes on, you may release the [A>M] button.
Menu Resetting
Use this procedure to restore the Menu settings to their factory defaults, without affecting the memories you have programmed.
1.Press the front panel’s [POWER] switch to turn the transceiver off.
2.Press and hold in the [MENU] button; while holding it in, press and hold in the front panel’s [POWER] switch to turn the transceiver on. Once the transceiver comes on, you may release the [MENU] button.
Full Reset
Use this procedure to restore all Menu, Memory settings, and Tuner Memory settings to their original factory defaults. All Memories will be cleared out by this procedure.
1.Press the front panel’s [POWER] switch to turn the transceiver off.
2.Press and hold in the [FAST] and [LOCK] buttons; while holding them in, press and hold in the front panel’s [POWER] switch to turn the transceiver on. Once the
transceiver comes on, you may release the other two switches.
Important Note: When the optional µTuning Kit is connected to the
Installation and Interconnections
Antenna Considerations
The
10 | Vertex Standard Co., Ltd. |
