FT-950
Operating Manual
3.Rotate the [SELECT] knob to select Menu item “044 A1A DELAY”.
Advice: Press the [SELECT] knob to toggle the Menu item display between “044 A1A” and “DELAY”.
4.Start sending, rotate the
5.When you are finished, press and hold in the [MENU] button for two seconds to save the new setting and exit to normal operation.
CW Pitch Adjustment
You may allow adjustment of the center frequency of the receiver passband, as well as the pitch of your offset CW carrier, to the tone you prefer via the Menu item “045 A1A PITCH”. The tone may be varied between 300 Hz and 1050 Hz, in 50 Hz steps.
1.Press the [MENU] button to enter the Menu mode.
2.Rotate the [SELECT] knob to select Menu item “045 A1A PITCH”.
Advice: Press the [SELECT] knob to toggle the Menu item display between “045 A1A” and “PITCH”.
3.Rotate the
4.When you are finished, press and hold in the [MENU] button for two seconds to save the new setting and exit to normal operation.
Advice: You may confirm the Spot tone frequency when pressing the [SPOT] button. The frequency display will shows the Spot tone frequency.
Terminology: CW Pitch: If you tuned to an exact “zero beat” on an incoming CW signal, you could not copy it (“Zero beat” implies a 0 Hz tone). Therefore, the receiver is offset several hundreds of Hz (typically), so as to allow your ear to detect the tone. The BFO offset associated with this tuning (that produces the comfortable audio tone) is called the CW Pitch.
Contest Memory Keyer
The
83 | Vertex Standard Co., Ltd. |
