Vertex Standard FT-950 manual General Group, Gene ANT SEL, Gene CAT BPS

FT-950

Operating Manual

022 KEY CW MEM4

Function: Permits entry of the CW message for message register 4.

Available Values: tyP1/tyP2

Default Setting: tyP2

tyP1: You may enter the CW message from the Main Tuning Dial knob and [CLAR/VFO-B] knob.

tyP2: You may enter the CW message from the CW keyer.

023 KEY CW MEM5

Function: Permits entry of the CW message for message register 5.

Available Values: tyP1/tyP2

Default Setting: tyP2

tyP1: You may enter the CW message from the Main Tuning Dial knob and [CLAR/VFO-B] knob.

tyP2: You may enter the CW message from the CW keyer.

GENERAL Group

024 GENE ANT SEL

Function: Sets the method of antenna selection.

Available Values: bAnd/rEG

Default Setting: bAnd

bAnd: The antenna is selected in accordance with the operating band.

rEG: The antenna is selected in accordance with the band stack (different antennas may be utilized on the same band, if so selected in the band stack).

025 GENE BEP LVL Function: Sets the beep level. Available Values: 0 ~ 100 Default Setting: 50

026 GENE CAT BPS

Function: Sets the transceiver’s computer-interface circuitry for the CAT baud rate to be used.

Available Values: 4800/9600/384H (38400) bps

Default Setting: 4800 bps

114 Vertex Standard Co., Ltd.